Yealink: find the IP address and log in
Almost every Yealink setting is reachable from the phone web page. To open it you need the phone on your network and its IP address.
Find the IP address on the phone
- Press and hold the OK key for a few seconds, or go to Menu → Status → Network. On older T2x models this is Menu → Status.
- Note the IPv4 or IP Address value, for example 192.168.0.10.
Log in
- Enter that address in a browser on a computer on the same network, for example http://192.168.0.10
- Log in as administrator. The factory default is admin / admin.
If the page will not load
- Check the computer is on the same network, not a guest or mobile network.
- Yealink phones fall back to 192.168.0.10 when they cannot get an address by DHCP.
- If the phone was supplied pre-configured by ArmourTel, the administrator password will not be the factory default. Ask us and we will provide it.