Cisco: find the IP address and log in

Cisco phones come from two quite different families and it helps to know which you have before following any guide.

  • SPA series - SPA112 and SPA122 adaptors, SPA30x, SPA50x and SPA52x desk phones. These are configured from their own web page.
  • MPP series - 6821, 6841, 6851, 7811, 7821, 7841, 8841 and similar. These are normally configured automatically by a provisioning server and their web interface is deliberately limited.

Find the IP address on the phone

  1. On an SPA phone press the Setup button, or the Settings key, and look for Network or Status → Network Status.
  2. On an MPP phone press Applications or Settings → Status → Network Status.
  3. Note the IPv4 Address value.

Log in

  1. Enter that address in a browser, for example http://192.168.0.1
  2. On SPA models log in as admin / admin. Some SPA firmware uses cisco / cisco.
  3. On MPP models the administrator password is set during provisioning. If you do not have it, ask us.

Important

If ArmourTel supplied a Cisco MPP phone pre-configured, do not factory reset it. It collects its settings automatically and a reset will interrupt that. Raise a ticket instead.

ArmourTel · www.armour.tel · support@armour.tel