Cisco: register a SIP line

The method depends on whether you have an SPA series phone or an MPP series phone. Have your ArmourTel SIP credentials ready; they are in your ArmourTel portal.

SPA series (SPA30x, SPA50x, SPA52x, SPA112, SPA122)

  1. Open the phone web page and log in as administrator, as described in Cisco: find the IP address and log in.
  2. Go to Voice → Ext 1. On the SPA112 and SPA122 adaptors this is Voice → Line 1.
  3. Under Proxy and Registration set Proxy to the SIP server from your portal.
  4. Under Subscriber Information set User ID to the SIP username and Password to the SIP password.
  5. Set Register to Yes.
  6. Click Submit All Changes.

MPP series (68xx, 78xx, 88xx)

These phones are normally provisioned automatically. If yours was supplied by ArmourTel it should register without any manual configuration once it is on a working network with internet access. If it has not registered after a few minutes, check the network and then raise a ticket rather than entering the details by hand, because a manual change may be overwritten by the configuration server.

Check it worked

On an SPA phone, Status → System Information or the line key will show whether the line registered. If it does not, see Phone will not register and confirm SIP ALG is disabled on the router.

ArmourTel · www.armour.tel · support@armour.tel