Snom: register a SIP identity

Have your ArmourTel SIP credentials ready first. The SIP username, password and registrar are in your ArmourTel portal.

Log in to the phone

  1. Find the IP address and open the phone web page as described in Snom: find the IP address and log in.
  2. Log in as admin.

Configure the identity

  1. Go to Setup → Identity 1. On older firmware this is Advanced → Identity 1.
  2. On the Login tab set Account to the SIP username from your portal and Password to the SIP password.
  3. On the SIP tab set Registrar to the SIP server from your portal.
  4. Set Identity active to on.
  5. Leave the outbound proxy empty unless we have told you otherwise.
  6. Click Save and then Reboot if prompted.

Check it worked

On the phone, the line key or function key for that identity should show the extension rather than a crossed-out icon. On the web page, Status → SIP Identity Status should read Registered.

If it stays unregistered, see Phone will not register and confirm SIP ALG is disabled on the router.

ArmourTel · www.armour.tel · support@armour.tel