Snom DECT: register a handset to the M-series base

Snom DECT systems use an M-series base station with M-series handsets. As with most DECT systems the SIP account is configured on the base station, and the handset is then registered to the base and assigned to a line.

Common combinations

  • M300 or M400 base with M25, M30, M65, M70 or M80 handsets
  • M900 multi-cell base for larger sites with M85 or M90 handsets

Register the SIP identity on the base

  1. Find the base station IP address from its display and open its web page. Log in as admin.
  2. Go to Setup → Identity 1 and enter the Account, Password and Registrar from your ArmourTel portal.
  3. Set Identity active to on and save.

Register a handset

  1. On the base web page open Settings → DECT → Registration (the exact wording varies by firmware). This puts the base into registration mode.
  2. On the handset press Menu → Settings → Registration → Register handset.
  3. Select the base when it is found. Registration normally completes within a few seconds.

Assign the handset to a line

Back on the base web page, assign the registered handset to the identity you configured. A handset registered to the base but not assigned to an identity will show as having no line.

ArmourTel · www.armour.tel · support@armour.tel