Yealink DECT: handset shows No Service or will not register

On a Yealink DECT system the base station holds the SIP account, so a handset showing No Service is usually one of three things. Working out which one saves a lot of time.

Work through these in order

  1. Is the base registered? Open the base station web page and check Status → Account Status. If the account shows Register Failed the problem is on the base, not the handset. See Phone will not register.
  2. Is the handset registered to the base? Check Status → Handset on the base. If the handset is not listed, register it again as described in Yealink DECT: register a handset to the base station.
  3. Is the handset assigned to a line? In Account → Number Assignment, make sure the handset is assigned to the account. A registered handset with no line shows No Service.

Other things worth checking

  • Range. Move the handset next to the base. DECT range through thick walls is much shorter than the headline figure.
  • Batteries. A handset that has been off charge for a long time may need 30 minutes on the charger before it will register.
  • Firmware. If you have added a newer handset to an older base and it will not register at all, the base may need a firmware update.

If the base registers but handsets keep dropping off, raise a ticket with the base model and firmware version shown on Status → System Status.

ArmourTel · www.armour.tel · support@armour.tel