Articles in this category Yealink: find the IP address and log in Almost every Yealink setting is reachable from the phone web page. To open it you need the phone on your network and its IP address. Find the IP address on the phone Press and hold the OK key for a f... Yealink: register a SIP account Before you start, have your ArmourTel SIP credentials to hand. The SIP username, password and server are in your ArmourTel portal. Each account needs its own credentials. Log in to the phone Find the... Yealink DECT: register a handset to the base station Yealink DECT systems have a base station and one or more cordless handsets. The important point is that the SIP account is configured on the base station, not on the handset. The handset only needs re... Yealink DECT: handset shows No Service or will not register On a Yealink DECT system the base station holds the SIP account, so a handset showing No Service is usually one of three things. Working out which one saves a lot of time. Work through these in order ... Yealink: factory reset a desk phone A factory reset clears every setting, including the SIP account, the administrator password and any provisioning details. If the phone was supplied pre-configured by ArmourTel it will need configuring...