Yealink: factory reset a desk phone
A factory reset clears every setting, including the SIP account, the administrator password and any provisioning details. If the phone was supplied pre-configured by ArmourTel it will need configuring again afterwards, so try a simple reboot first.
From the phone menu
- Press Menu → Settings → Advanced Settings and enter the administrator password. The factory default is admin.
- Choose Reset to Factory, or Reset → Reset to Factory Settings depending on firmware.
- Confirm and wait for the phone to restart.
If you cannot get into the menu
- Web interface: log in as administrator, then look under Settings → Upgrade for Reset to Factory. The exact position varies by firmware.
- Physical button: with the phone powered on, press and hold the reset button on the underside for around 10 to 15 seconds until the screen prompts you.
After the reset
The phone returns to its default address of 192.168.0.10 if it cannot get one by DHCP, and the administrator password returns to admin. Register the account again using Yealink: register a SIP account.