Yealink DECT: register a handset to the base station

Yealink DECT systems have a base station and one or more cordless handsets. The important point is that the SIP account is configured on the base station, not on the handset. The handset only needs registering to the base and then assigning to a line.

Common combinations

  • W60B with W56H or W53H handsets
  • W70B with W57R, W59R or W73H handsets
  • W80DM or W80B with T41S, T42S, T43U, T46U or T48U handsets

Register the SIP account on the base

  1. Open the base station web page. The default address is 192.168.0.10 and the default login is admin / admin.
  2. Go to Account → Register and open the account you want to use.
  3. Enter Register Name, User Name, Password and SIP Server from your ArmourTel portal.
  4. Set Line Active to Enabled and press Confirm.

Register a handset to the base

  1. On the base web page open Status → Handset. Some firmware calls this Handset & Account → Handset Registration.
  2. On the handset press Menu → Settings → Registration → Register Handset, or hold the Reg soft key.
  3. Choose the base when prompted. It appears as Base 1 and should register within a few seconds.

Assign the handset to a line

On the base web page open Account → Number Assignment and assign the handset to the account you registered. Without this the handset shows No Service even though the base is registered.

ArmourTel · www.armour.tel · support@armour.tel