Cisco DECT: register a handset to the base station

Cisco DECT systems use a base station with cordless handsets. The SIP account is configured on the base station, not on the handset.

Common combinations

  • 6825 base with 6823 or 6825 handsets, for small sites
  • 6861 multi-cell base with 6865 handsets, for larger sites and wider coverage

Register the SIP account on the base

  1. Find the base station IP address. On the 6825 it is shown on the base display. On the 6861 press the Status or Info button.
  2. Open the base web page and log in as administrator.
  3. Enter the SIP account, password and server from your ArmourTel portal and save.

Register a handset

  1. On the base web page open the DECT or Handset Management section and start handset registration.
  2. On the handset press Menu → Settings → Registration → Register Handset, or hold the Register soft key.
  3. Select the base when it appears and wait for confirmation.

If the handset will not register

  • Make sure the base is in registration mode. It only accepts new handsets for a short time after you start it.
  • Bring the handset close to the base while registering.
  • On the 6861 check the handset is within range of a repeater or base that is powered and connected.
ArmourTel · www.armour.tel · support@armour.tel