TP-Link: prioritise voice traffic with QoS

Calls need only a small amount of bandwidth, but they need it consistently. QoS stops a large upload from making calls unusable.

Before you start

  • Measure your actual upload speed at a quiet time. QoS on TP-Link is set as a percentage of the figure you enter, so an optimistic number here makes QoS ineffective.
  • Give each phone a fixed IP address, either static or by DHCP reservation, so you can identify it reliably in the rules.

On an Archer router

  1. Log in as administrator and go to Advanced → QoS, or Bandwidth Control on some firmware.
  2. Enter your measured upload and download speeds. Set them slightly below the measured values, for example 90 per cent, so the router queues traffic rather than the modem dropping it.
  3. Add the phones by IP address and set them to the highest priority.
  4. Save the settings.

On an Omada or business router

  1. Go to Transmission → Bandwidth Control and enter the line speeds.
  2. Create a rule for the phone addresses, or for the voice VLAN if you have one, with the highest priority and a guaranteed minimum.
  3. Allow roughly 100 kbps each way per simultaneous call, so ten concurrent calls needs about 1 Mbps reserved.

Check it worked

Start a call, then begin a large upload from a computer on the same connection. The call should stay clear. If it still breaks up, the upload speed entered in the router is probably higher than the line can sustain.

ArmourTel · www.armour.tel · support@armour.tel