Draytek Vigor: separate voice and data with VLANs

Putting phones on their own VLAN keeps voice traffic away from large downloads and gives you a clean way to prioritise calls. It also makes troubleshooting easier, because you can see exactly which devices are phones.

What you need first

  • A Vigor router that supports VLANs, such as most 2762, 2765, 2862, 2865 and 2927 models.
  • A switch that understands VLAN tags, if phones and computers share one switch.
  • Phones that support VLAN tagging. Yealink, Snom, Cisco and Fanvil phones all do, usually under Network → VLAN in the phone web interface.

On the router

  1. Log in as administrator and go to LAN → VLAN Configuration. On some models this is LAN → VLAN or under VLAN Tagging.
  2. Enable VLAN configuration.
  3. Create a VLAN for voice, for example VLAN 10, and a separate one for data, for example VLAN 20.
  4. Set the voice VLAN to tag traffic on the ports used by phones.
  5. If phones and computers share a port, configure the phone port as tagged for voice and untagged for data so the PC downstream of the phone stays on the data VLAN.

On each phone

  1. Open the phone web interface and go to Network → VLAN or Advanced Network.
  2. Enable VLAN, set the Voice VLAN ID to 10, and set the priority to 6 for voice.
  3. Save and let the phone reboot. It will take a new address on the voice VLAN.

Watch out for

  • If the voice VLAN has its own DHCP scope, make sure it hands out a gateway and DNS server.
  • Get the VLAN working before adding QoS rules, otherwise you will not know which change caused a problem.
ArmourTel · www.armour.tel · support@armour.tel