Draytek Vigor: prioritise voice traffic with QoS

Voice calls need very little bandwidth but they need it consistently. QoS will not create capacity that is not there, but it stops a large upload from ruining calls.

Before you start

  • Know your true upload speed. Run a speed test at a quiet time and note the upload figure, because QoS is configured as a percentage of it.
  • Give the phones fixed addresses, either static or by DHCP reservation. You cannot prioritise by IP address reliably if the addresses change.

Configure QoS on the router

  1. Log in as administrator and go to Bandwidth Management → QoS. On some firmware this is QoS Control or Bandwidth Management → Sessions Limit plus a QoS tab.
  2. Enable QoS and enter your measured upload and download speeds. Set them slightly below the measured figures, for example 90 per cent, so the router queues traffic rather than the modem dropping it.
  3. Create a class for voice with a high priority and a guaranteed minimum bandwidth of around 100 kbps per concurrent call. Allow roughly 100 kbps each way per call, so ten simultaneous calls needs about 1 Mbps reserved.
  4. Add the phones to that class by IP address or by the VLAN you created for voice.
  5. Apply the settings.

Check it worked

Start a call and then begin a large upload from a computer on the same connection. The call should stay clear. If it still breaks up, the upload speed entered in the router is probably higher than the line can actually sustain.

Related reading

Poor call quality: choppy, crackling or breaking up covers what to check when the network itself is the problem.

ArmourTel · www.armour.tel · support@armour.tel