TP-Link: separate voice and data with VLANs

Putting phones on their own VLAN keeps voice traffic separate from downloads and makes prioritisation far easier. Support varies a lot across the TP-Link range, so start by checking what your model can do.

What your model supports

  • Business and Omada routers such as the ER605, ER7206 and similar: full VLAN support.
  • Omada access points and managed switches: full VLAN and SSID-to-VLAN mapping.
  • Consumer Archer routers: usually no VLAN support at all. If you need VLANs on an Archer network you will need a managed switch or a different router.
  • Deco mesh: no usable VLAN support on most models.

On an Omada or business router

  1. Log in to the router web interface as administrator.
  2. Go to Transmission → VLAN and create a VLAN for voice, for example VLAN 10, and one for data, for example VLAN 20.
  3. Assign the VLANs to the ports that carry phones.
  4. If phones and computers share a port, tag the port for the voice VLAN and leave the data VLAN untagged, so a computer connected through the phone stays on the data VLAN.

On each phone

  1. Open the phone web interface and go to Network → VLAN or Advanced Network.
  2. Enable VLAN, set the voice VLAN ID to 10, and set the priority to 6.
  3. Save and allow the phone to reboot onto the voice VLAN.

Watch out for

  • If the voice VLAN has its own DHCP scope, it must provide a gateway and DNS server.
  • Confirm phones register on the new VLAN before you add QoS rules, so you can tell which change caused any problem.
ArmourTel · www.armour.tel · support@armour.tel