Draytek Vigor: disable SIP ALG

SIP ALG is the single most common cause of phones that will not register or that lose audio after a few minutes. It is worth disabling even when everything currently works, because it tends to fail intermittently under load.

For background on what SIP ALG is and why it breaks VoIP, see SIP ALG: what it is and how to disable it.

On most Vigor routers

  1. Log in to the router web interface as administrator.
  2. Go to NAT → ALG. On older firmware this is NAT → ALG / SIP ALG, and on some models WAN → NAT → ALG.
  3. Clear the SIP checkbox, and the RTSP and H.323 boxes too if they are present. None of them help hosted VoIP.
  4. Click OK or Apply.
  5. Reboot the router, then power-cycle the phones.

Things to watch for

  • Firmware versions move this setting. On newer firmware it sometimes sits under Firewall or under the VoIP configuration rather than NAT. Use the router search or look for a setting containing ALG.
  • SIP Passthrough is different and can be useful. If you run your own PBX on site, SIP Passthrough is the setting that forwards SIP traffic to it. Do not confuse it with SIP ALG.
  • Do not use the built-in VoIP ports. On Vigor models with their own phone ports, leave them unconfigured if you are using hosted extensions.

Check it worked

Reboot the phones and confirm they register. See Phone will not register for what to check next if they still do not.

ArmourTel · www.armour.tel · support@armour.tel