SIP ALG: what it is and how to disable it
What is SIP ALG?
SIP ALG (Application Layer Gateway) is a feature on many routers that tries to inspect and rewrite VoIP (SIP) traffic to help devices behind NAT. It is on by default on many routers and is frequently implemented poorly.
Why it causes problems
A broken SIP ALG rewrites SIP packets incorrectly, which causes:
- Phones that will not register, or that register intermittently.
- Incoming calls that never ring.
- One-way or no audio.
- Calls that drop after a short time.
What to do
- Log in to your router (usually at 192.168.1.1 or 192.168.0.1 — check your default gateway).
- Find the SIP ALG (or SIP passthrough / SIP transformations) setting and turn it off.
- Reboot the router, then the phone.
Where the setting is on common routers
| Router | How to disable SIP ALG |
|---|---|
| Asus | Advanced Settings → WAN → NAT Passthrough → disable SIP Passthrough |
| BT Home Hub / Sky Hub / Virgin SuperHub / Fritz!Box | Cannot be disabled in the interface — use the workarounds below |
| D-Link | Advanced → Application Level Gateway (ALG) → untick SIP |
| DrayTek | Network → NAT → ALG (or sys sip_alg 0 via telnet) |
| Huawei (EE / TalkTalk / Vodafone) | Security → SIP ALG Settings → untick Enable SIP ALG |
| MikroTik | Disable the SIP Helper |
| Netgear | WAN setup → untick SIP ALG |
| TalkTalk | Port Forwarding → untick SIP-ALG |
| TP-Link | Advanced Setup → NAT → ALG → untick SIP |
| ZyXEL | Network or Advanced → ALG → untick Enable SIP ALG |
If you cannot disable SIP ALG
- Enable TLS on the phone — this encrypts SIP signalling so the ALG cannot inspect it.
- Or replace the router with one that lets you disable SIP ALG.